TECHNINIŲ DUOMENŲ LAPAS
Luminol Clear 25 - Water-borne UV-curing lacquer
|APIBŪDINIMAS||A water-borne, UV curing urethane lacquer.|
|Paskirtis||Excellent resistance to abrasion and chemicals. Recommended for furniture, doors of kitchen fittings, interior doors and other wooden surfaces.|
|Spalvų katalogai||Different colours can achieved by using Akvi Color stains under lacquer film.|
|Blizgumo standartas||ISO 2813/60º|
9,1 m²/l with 35 µm DFT, without thinning and applicated 93 g/m² wet weight.
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Airless spraying application with the viscosity 50 - 70 seconds (DIN 4) can be reached with approximately 0 -5 % of thinning by volume. Nozzle tip 0.011" to 0.015" is recommended to use with the pressure of 100 - 160 bar. Spray angle shall be chosen according to the shape of the object.
Air assisted airless application with the viscosity 50 - 70 seconds (DIN 4) can be reached with approximately 0 -5 % of thinning by volume. Nozzle tip 0.011" - 0.015" is recommended to use with the pressure 40 - 140 bar. Atomising air pressure should be about 2 bar. Spray angle shall be chosen according to the shape of the object.
Conventional application with the viscosity 50 - 70 s (DIN 4) can be reached with approximately 0 - 5 % thinning by volume. Nozzle tip 1.4 - 1.8 mm is recommended to use with the pressure 2,0 - 3,0 bar.
Drying times (100 - 120 g/m2)
Dry to sand immediately after UV-curing.
Dry to stack immediately after UV-curing.
Flash Off 2-4 minutes needed before conventional drying. Flash off times are related to the film thickness, temperature, the relative humidity of the air and ventilation. Drying time is related to the UV-energy.
|Sausasis likutis||32 ± 2 % by volume, 29± 2 % by weight.|
|Sandėliavimas||12 months (+23 ºC).|
|Gaminio kodas||005 3330|
|Dengimo sąlygos||The surface to be lacquered has to be clean and dry. During application and drying the temperature of the air, the surface to be treated and the lacquer has to be over 18 ºC and the relative humidity of the air below 70 %.|
|Paviršiaus priežiūra||Wood surfaces must be sanded with roughness P150 - 240. All sanding dust must be removed with f.ex. air exhauster.|
|Komponentų maišymas||Stir the lacquer carefully before use. Thin the lacquer to the viscosity required with water. Do not use iron containers as mixing container. Instead use plastic, enamel or acid resistant steel containers.|
|Lakiųjų organinių junginių kiekis (LOJ) (direktyva 2004/42/EB)||Maximum VOC content in ready to use mixture is 30 g/l.
For industrial use only.
|SAUGOS IR SVEIKATOS APSAUGOS ŽENKLINIMAS|
pagal reglamentą EB Nr. 1272/2008
|Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.|