Fontecryl PP - Water-borne acrylic primer

APIBŪDINIMAS A waterborne, one component fast drying acrylic based primer containing active anticorrosive pigments.
SAVYBĖS Recommended e.g. as an anti-corrosive primer under powder coatings on steel. Especially suitable for dipping. Drying times can be shortened by using higher temperatures. Overcoatable with a wide range of products, also with solventborne products.
Paskirtis Steel surfaces.

Spalva Grey and yellow.
Blizgumas Matinis
Teorinė išeiga

Recommended film thicknesses

Theoretical coverage




15 µm

30 µm

32.0 m2/l

30 µm

65 µm

16.0 m2/l

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Skiediklis Vanduo
Įrankiai By dip or conventional spray.
Džiūvimo laikas

DFT 30 µm

+ 23 ºC

Dust dry, after

20 min

Touch dry, after

30 min

Through dry, after

24 h

Recoatable with powder coatings, after

Note! Before overcoating all the solvents and water have to be evaporated from the primer.

20 - 30 min

Through dry at increased temperatures after 15 min / 60 ºC

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Sausasis likutis 48 ± 2 % volume
Tankis 1.2 - 1.3 kg / l
Gaminio kodas 006 5980 and 006 5981

Dengimo sąlygos All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should be between 20 - 70 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
Paviršiaus paruošimas Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.
Viršutinio sluoksnio danga FONTECRYL 25, FONTECRYL 50 and powder coatings.
Dažymas By dip or conventional spray. Depending on the application method the paint can be thinned 0 - 10 %. At dipping the viscosity should be 15 - 20 s DIN 4 and at conventional spray application 20 - 30 s DIN 4. Before overcoating all the solvents and water have to be evaporated from the primer.

Note! The viscosity falls quickly when thinning the paint.
Įrankių valymas FONTECLEAN 1921.
Lakiųjų organinių junginių kiekis (LOJ) (direktyva 2004/42/EB) The Volatile Organic Compounds amount is 40 g/litre of paint.
VOC content of paint (thinned 10 % by volume) is 35 g/l.

pagal reglamentą EB Nr. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.
Saugos duomenų lapasFontecryl PP